Do you know how to solve the problem of the condenser of the compressed air dryer? Now let me tell you about it!

1. The condenser or cooler fins are blocked and need to be cleaned. Abnormal cooling water also requires water-cooled condenser and water filter blockage. To improve the cooling water or clean the condenser, a water filter is required.

2. The evaporated water vapor can be discharged in time and then be treated well, so that the pressure inside the steam exhaust cylinder can also be a good control parameter.

3. This will cause the drum dryer to be idle for many years.

4. How to solve the problem of the compressed air dryer? This will cause the hot air to flow poorly, the heat exchange is not good, and the flue gas can return from the combustion chamber.

5. Accidents of the vibrating feeder are too frequent (mainly burnt coils, etc.) and the location is high, maintenance is also very inconvenient, and sometimes maintenance workers can remove it.

6. If the solid-liquid separation process can use a plate and frame filter press, the filter cake can also be broken with a slag breaker before feeding. At the same time, the tools can be prepared before starting up.

7. Therefore, under normal circumstances, the hot air inlet temperature is controlled at 800~900oC, so there is no need to blindly increase the temperature in pursuit of output.

8. Excessive vibration of the induced draft fan: It is necessary to immediately check whether the bearing is damaged, whether there are other adhesives on the impeller, and it needs to be cleaned and repaired immediately. Foreign customers inspecting the tumble dryer also need materials that can be stacked on the L-shaped lifting plate for a period of time after falling, and they need to be in contact with the surface materials and hot air, and the inside of the pile must not be in contact with hot air. Yes, so the material can be dispersed at a relatively low degree on the cross section, and it is not sufficient or allowed to contact with hot air.